Home Painting

How to Repair Outdoor Wicker

Wicker, while largely durable, has certain characteristics which make it vulnerable to harm. This is especially true during times of rain and warmth when spells of moisture and the following dryness which follows have unfavorable consequences on the furniture. From cracked reeds to ends that have frayed or curled, these imperfections are relatively simple to fix.

Cracked Wicker

Cracks in wicker furniture are not terribly uncommon, and also the culprit generally is excessive dryness. The remedy is moisture. Rehydrate the damaged wicker with boiled linseed oil. It’s important to be aware that because linseed oil is very flammable, buy it packaged as being boiled and never attempt to boil it yourself. Apply the boiled linseed oil to the cracked wicker using a brush in a well-ventilated place, paying special attention to each one the crevices of this furniture. Keep using the oil before the wicker no longer absorbs it. Remove excess oil with a clean towel and allow the furniture to dry for at least 24 hours.

Curled Ends

The trick to successfully adjusting endings or pieces of wicker which come loose and start to curl is always to work with wet reeds; this assists in manipulating the wicker back in position. To acquire the wicker for this point, cover the reeds in need of repair with wet towels for 30 to 60 minutes. If you find that following this period that the wicker still resists motion, don’t force it. Soak it again until the reed readily goes to the place you want. Once in place, tuck the end back in the furniture’s frame and hold it in position with tacks as a temporary remedy. Following the wicker has dried, use a little bit of wood glue onto the end and hold it into place with your fingers or tacks until the adhesive dries, too.

Fixing Strands of Wicker

If your wicker furniture demands the replacement of a strand, then the fix can be achieved at home. Soak the substitute wicker fiber in warm water for 30 minutes. This makes it easier to bend and weave throughout the furniture frame. Cut each end of this broken reed to get rid of it from the furniture. Quantify the new strand contrary to the one you just removed and wrap the damaged area. Once you place the new strand, then snip off any excess material and tuck the finish underneath an intersecting piece. You will find it easiest to hold the new reed set up with tacks before the new, damp wicker dries. Fasten the ends in place with wood glue after the reed has dried. Once the adhesive has dried, It’s possible to remove the tacks.

Painting New Wicker

Depending on the type of fix the wicker needed, you there could be new areas which are not exactly the exact same colour or finish as the rest of the piece. For mismatched coloring, spray paint the fixed areas after the repairs are finished and the wood adhesive is dry. Begin by employing just a light coat of spray paint, carefully blending the new paint together with the surrounding areas. Insert thin coats as needed until the new pieces are adequately blended.

See related