Home

The best way to Close Off a Bathroom Drain

There may be several causes a bathroom will require to be capped or closed-off. In places of flooding, closing to the bathroom, or maybe the bathroom is no longer required in that specific location of the home and a bathroom drain will stop raw sewage. The seal will require to be equally air- and watertight to avoid equally sewer fumes from breaching the drain and waste-water. Most bathroom drains are standardized, but on homes or older, there may be a variation in bathroom drain circumference that has to be accounted for.

Remove the bathroom. Turn the feed valve off, drain the water in the tank, eliminate the bolts using a wrench and unhook the feed line. Pull the bathroom up and from the way.

Remove its own remnants and the gasket in the toilet flange. A wax gasket has to be scraped out using a little putty knife, although a rubber gasket pulls from the flange.

Measure the dimensions of the drain hole on the other side of the top. 3 or 4″ will be measured both by all bathrooms. This measurement will know what what size plug or cap you are going to use.

Check in the flange for threads. You’ll be in a position to use a cap whether there are threads.

Get the properly sized plug or cap. A cap will fit on the sides of the flange as well as a plug will fit in the flange. Where as caps are considered permanent plugs are usually regarded short-term. Choose the correct application to your needs.

Pound a plug to the toilet drain using a rubber mallet. Plugs are made from rubber but some are wood. Pound on the best before the plug is firmly seated.

Insert a twist plug in to the drain and change the middle screw. You are going to be in a position to use your fingers to tighten the plug. Tighten the screw to get a seal that is full.

Turn a screwcap that is threaded to the drain. Coat the threads with pipe dope to ensure an air tight seal. Turn the cap in to place by means of your hand.

Cap off the drain with a bathroom protect. All these are generally manufactured from rubber or the cap is PVC having a rubber skirt. The drain is actually capped off by them while the skirt is clamped round the pipe with hose clamps utilizing a screw-driver or little wrench.

See related